DIY Third/Helping hand for electronics

 Hi viewers,

Today I will show you how to make a helping hand for electronics..! 

(a)

 Figure (a) shows you the final product: The helping hand

To make this helping hand the required materials as follows:

1. Base 

2. Wire (make sure that it is strong enough)

(b)

3. Crocodile clips x2

(c)

4. Light (I had taken this from my old LED lamp which was broken)

(d)

5. Glue gun

6. 9v battery

Procedure:

Step 1: Connect the crocodile clips to one end of the wire.

(e)

Step 2: Glue the other end of the wire and stick it to the base.

Step 3: Now, tighten up the LEDs to another wire.

Step 4: Glue the other end of the wire and stick it to the base.

Step 5: Finally, connect the battery to LEDs 

Your DIY helping hands are ready with light.

Note 1: Make sure to have a tough wire which is single led wire i.e. 3mm to 5mm of diameter.

Note 2: You need a heavyweight base I have chosen an aluminum sheet, of course, it is a lightweight but taken a larger size. As these aluminum sheets are used in home decorating etc.

Finally, to do this I have spent 30/- on those crocodile clips and all other stuff is at home.  

If you want to purchase these helping hands go through the following links:

1. This one price is too high but having more accessories click here. 

2. This one also the same as above at a lower price click here.

3. This one is good for beginners at a low price click here.

...Thank you for viewing my project...